Zūm™ Wireless ELV Wall-Box Dimmer, 120-277V, Gray Smooth
A wireless wall-box dimmer for 120-277 Volt load control of dimmable electronic low-voltage halogen or LED, incandescent, tungsten-halogen, electronic CFL, and 2-wire fluorescent ballasts in a Zūm™ commercial lighting system.
Model ZUMMESH-DELV-W-S shown. Faceplate sold separately.
The Zūm™ wireless ELV wall-box dimmer (ZUMMESH-DELV Series) provides control of a single 120-277 Volt lighting load consisting of dimmable electronic low-voltage (halogen or LED), incandescent, tungsten-halogen, electronic CFL, and 2-wire fluorescent ballasts. It features a single rocker switch to enable simple on/off switching and dimming adjustment, with the ability to save one preset. Standard gang-box installation allows one or more units to be installed in a 3-1/2 inch (89 mm) deep electrical box (decorator-style faceplate sold separately).
Zūm Mesh wireless technology affords easy “pair and play” integration as part of a complete Zūm commercial lighting system. Energy-saving options are available to enable daylighting, occupancy or vacancy sensing, and centralized monitoring and management.[1]
Energy Efficiency
Occupancy sensor, vacancy sensor, and daylight sensor connectivity drive the potential for significant energy savings. Lights will turn off automatically when the room is vacant and dim gradually according to the amount of natural daylight in the room. This reduces energy usage while maintaining a consistent light level for a comfortable workspace.
Pair and Play Setup
Designed with flexibility and ease-of-use in mind, Zūm dimmers are pre-programmed with “pair and play” functionality. An installer can simply install the dimmer in a room along with Zūm occupancy or vacancy sensors and/or a daylight sensor, set up the room with a few quick button taps, and then use the dimmer to control the lights in the room – no programming required! Room setup can also be accomplished using the Zūm app if the room is equipped with a Zūm Network Bridge. The Zūm Network Bridge also enables centralize monitoring and management via a Zūm Floor Hub and Zūm Net Wireless Gateway.[1]
Zūm Mesh Wireless Technology
Ultra-reliable Zūm Mesh wireless technology provides steadfast peer-to-peer RF communications within a commercial space without the need for physical control wiring, hubs, or gateways. Employing a 2.4 GHz peer-to-peer mesh network topology, nearly every Zūm Mesh device acts as a “routing node,” relaying wireless commands directly between Zūm Mesh devices to ensure that every command reaches its intended destination without disruption.
Zūm Mesh is smart! Every Zūm Mesh device knows its purpose and just the right messages to communicate to other Zūm Mesh devices within the space. Each Zūm Mesh device that is added to the space effectively increases the range and stability of the peer-to-peer mesh network by providing multiple redundant signal paths. Each Zūm Mesh device auto-negotiates its RF channel to provide robust communication and is protected through AES 128-bit encryption. The wireless range between any two Zūm Mesh devices is typically 50 feet (15 meters).[2]
Please refer to the Zūm Lighting Control System Setup Guide (Doc # 7957) for additional information.
Key Features
- Zūm™ wireless ELV wall-box dimmer
- Pair and play with Zūm occupancy sensors, vacancy sensors, and daylight sensors [1]
- Zūm Mesh peer-to-peer RF communications for easy integration into a complete standalone or networked Zūm wireless lighting control solution [2]
- Single rocker switch and status LED
- Reverse phase dimming technology
- Supports dimmable electronic low-voltage halogen or LED, incandescent, and electronic CFL lighting loads
- Rated 500 Watts at 120-277 Volts AC [3]
- Built-in air gap switch
- Flying lead wiring connections
- Standard 3-1/2 inch (89 mm) deep electrical box installation
- Available in smooth black, white, almond, gray, or red finish
- Matching decorator-style faceplate available separately
| Load Control |
| |
Dimmable Load Types |
Electronic low-voltage (ELV transformer for halogen or LED), incandescent, tungsten-halogen, electronic CFL, 2-wire fluorescent ballast |
| |
Line/Load Voltage |
120-277 Volts AC, 50/60 Hz, dedicated neutral wire required |
| |
Load Rating |
500 Watts maximum [3] |
| |
Minimum Load |
none |
| Wireless Communications |
| |
RF Transceiver |
Zūm Mesh 2-way RF, 2.4 GHz ISM Channels 15, 20, 25, or 26 (channel auto-selected), IEEE 802.15.4 compliant, AES-128 encryption |
| |
Range |
50 ft (15 m) to nearest peer-to-peer mesh network device(s), subject to site-specific conditions and individual device capabilities [2] |
| |
Note: A maximum of 32 Zūm Mesh wireless devices is permitted per room. |
| Controls & Indicators |
| |
Switch |
(1) Rocker switch (spring return to center); press up to recall the locally saved preset (turns the lighting load on at the saved preset dim level), press down to turn the lighting load off, press and hold up or down to raise or lower the dimming level; also used for creating a preset, room setup, and factory reset |
| |
Status |
(1) Green LED, indicates the lighting load is turned on; also used for creating a preset, room setup, and factory reset |
| |
Air-Gap Switch |
(1) Latching switch, opens the air-gap to de-energize the load output |
| Connections |
| |
Hot |
(1) 16 AWG (1.5 mm²) Class 1 flying lead, black, line power input |
| |
Neutral |
(1) 16 AWG (1.5 mm²) Class 1 flying lead, white, neutral |
| |
Ground |
(1) 16 AWG (1.5 mm²) Class 1 flying lead, green, ground |
| |
Load |
(1) 16 AWG (1.5 mm²) Class 1 flying lead, red, dimmed load output |
| Environmental |
| |
Temperature |
32° to 104° F (0° to 40° C) |
| |
Humidity |
10% to 90% RH (non-condensing) |
| Construction |
| |
Composition |
Plastic housing and front face with metal bracket |
| |
Mounting |
Mounts in a 1-gang (or larger) 3-1/2 inch (89 mm) deep electrical box (not included) |
| |
Faceplate |
Requires a decorator-style faceplate (sold separately) |
| Dimensions |
| |
Height |
4.13 in (105 mm) |
| |
Width |
1.75 in (45 mm) |
| |
Depth |
1.80 in (46 mm) |
| Weight |
| |
5 oz (142 g) |
| Compliance |
| |
ETL Listed for US & Canada, IC, FCC Part 15 Class A digital device, UL 1472, CSA C22.2 No.184.1 |
Click
here to search product certificates.
Please select your region below to see the appropriate Advertised Pricing.